Kit finally home..

Its been a long time coming but at last the chassis is in my garage.

VERY PICTURE HEAVY!

Wasn't too happy with it on three axle stands, I think it will be fine with some more weight but at the moment where its not putting much weight on the stands it does move around a fair amount. 

Took a load of pictures of the chassis as mine seemed a little different compared to some some in the other blogs I have seen. I guess MNR are constantly moving forward with the design.

So here are the rest of the bits that with the chassis and the extra parts I ordered.

Propshaft, roll bar side bars, push rods, a bar which I think is to do with the steering and the light bar.

Bulkhead cover,  not sure why but everyone who has popped in has asked what this is first..

Rear uprights, including bearings.

Drivers and passenger bulk head covers.

cover to wiring loom to pass through.

Front and Rear wish bones..  Must get these the right way round!!!

Steering rack mounts, some joints and a little rubber thingy for the steering.

Electric reverse motor..

Front and Rear suspension..  (Can't wait to get these fitted)

Rear hubs.

Front discs and hubs, really nice bit of kit these. Look fab!

Front wheel bearings.

Fuel line

Brake lines

Hand brake lever and hand brake switch

Hand brake cable

Front Calipers

Rear Calipers, comes with the hand brake part. These bad boys fit under 13" rims as standard!

Front Caliper carriers  (THESE WERE WRONG - REPLACED AT A LATER DATE)

Rear caliper carriers.

Brake fluid tank, mount and fixings

Pads..

Brake three way T pieces

Rear discs

Wiring loom and instructions

Front Rockets

Engine mounting kit, this is the standard parts that are used but Marc recommended fitting helicoils to the engine mounting points and fixing straight to these rather than using the threaded bar.

Alternative bolts for using with helicoils in the engine casing.

Sierra Diff, already refurbished, looks good.

CBR1000 Race Manifold

Front Suspension Rods (Might be wrong - waiting to find out)

Front headlight Bar and what I think is the lower part of the steering rod.

Lots of fixings

Front uprights

Pedal box

Everything boxed up until I need it.. Starting to look a little cluttered.