So the quickshifter normally piggy backs off the Honda loom. I am going to hardwire the quickshifter as all my wiring is located under the scuttle.
First off I disconnected the Honda clutch switch from my microswitch.
Then it was to locate the lines going to the top injectors.
They were easy to locate once I referred back to my wiring diagram.
All connected up to the quickshifter.
Hooked up to the PC, I enabled the quickshifter and turned on the single time mode.
Back together, was going to take it out for a spin but it was dark and cold!!! Fingers crossed for nice weather at the weekend.
No comments:
Post a Comment