Been having some issues with the engine mounts, just couldn't get the last one in. It was just so far off, I used bars and jacks to try and lift and move the engine about but it just wouldn't go in.
After speaking with a few of the guys on the owners club and Marc, it was suggested I remove the engine and drill out all mounts to ensure there was no powder coating in the mounts. Also when doing up the bolts only put them in a little at a time to make sure they are all in a little before tightening.
Finally got them all in and done up..
Some of the bolts needed alot of washers, on both sides. Not really happy with this so going to look at either cutting down the bolts I have or getting some more.
No comments:
Post a Comment