Ok have an issue with rotating the throttle bodies... Looks like the fuel line is stopping the bodies going fully down into the rubber seals.
Fitted again without the fuel line.. It goes into the seals fully, you can see how tight it is.
Sounds like the fix is to move the feed hose from the bottom. The only real place for it is halfway between these two fixings. I have ordered a brass T piece to test out.
This leaves the lower feed pipe to blank off.. Still working out how to do this.
Did try to rotate the two centre feed connectors but they are different which is annoying as it would be perfect!
No comments:
Post a Comment